It adheres perfectly and forms a rubbery film of great elasticity and totally impervious to water, once 16 to 24 hours have elapsed since its application. At the same time, it allows sufficient transpiration of water vapor.
Surface preparation
Cement surfaces; asbestos-cement, terracotta and old bituminous coatings should be clean of dust, dirt and dry. By brushing, chips and poorly adhered parts should be removed before proceeding to application. In the case of zinc-plated sheet, it must be clean, dry and perfectly degreased. Surfaces with cracks and gaps, not exceeding 1 millimetre, must be repaired beforehand.
Before applying
Working temperature: IT SHOULD NOT BE LOWER THAN +5ºC, NOR HIGHER THAN +40ºC Do not apply on very humid and / or rainy days. Avoid the application, when rains are expected before 16 hours of it.
How to use
Surfaces with cracks and gaps, not exceeding 1 millimetre, must be repaired beforehand. For this purpose, a paste composed of one part of TRANSPARENT TEPPIGUM and two or three parts of fine sand can be used. Dilution: 1st Hand: 5-15%, depending on the porosity of the surfaces to be painted. Successive hands: A viscosity of supply. Application: BUCKLE or ROLLER. Occasionally it can be applied to airbrush gun (2.8 mm nozzle) or air-less (Nozzle 0.021 or 0.023" and 30 mesh filter). On surfaces in good condition, two hands will suffice.
Storage
UP TO ONE YEAR in places protected from frost. If the container has been opened, close it tightly and use the contents within 30 days
Calculate how much you need:
It adheres perfectly and forms a rubbery film of great elasticity and totally impervious to water, once 16 to 24 hours have elapsed since its application. At the same time, it allows sufficient transpiration of water vapor.
