Suitable for the creation of highly resistant surfaces (walls and floors), continuous decorative floors and with high adhesion (any clean base such as cement, plasterboard, ceramic coatings after scratching, etc ...). Finishes similar to lime stuccos.
Surface preparation
The support must be clean, dry, free of contaminants such as dust, grease, oils, etc. And free of saltpeter, mold, algae, etc. On plasters, plasterboard or old paints apply 1 or 2 coats of FASSALINA. On metal or wood use suitable sealers. If the mineral support is badly damaged, first apply our ULTRAFINE JAYOKRIL as a consolidating primer. On mineral surfaces in good condition apply EGACEMENTI MEDIO directly.
Before applying
As for the recommended working temperature will be between 8 and 30 ºC, monitoring the real conditions of the support. On overheated or dry surfaces, slightly wet the surface with water.
How to use
A lower or greater consistency of the fresh product can be obtained when applying, for this, before preparing the mixture reserve approximately 15% by weight or volume of CATALYST EGACEMENTI. Once the mixture is homogenized and free of lumps, the reserved catalyst will be slowly added until it is observed that the viscosity is ideal for the application, regardless of whether part of the reserved catalyst is left over. In case of making a color the dye must be added on the CATALYST EGACEMENTI before mixing with the INTERMEDIATE EGACEMENTI. The ideal is to pour the INTERMEDIATE EGACEMENTI, solid, on the EGACEMENTI CATALYST, liquid, slowly and with electric mixer, Homogenize at high revolutions until the product is free of lumps. The life of the mixture is 2 hours. The application will be made to trowel, preferably of stainless steel; The mixture will spread with the trowel on a regular basis, but at the same time leaving spatulate that help us achieve harmonious effects. Once the first hand has dried or set, we will proceed to apply a second coat, using the same technique. The INTERMEDIATE EGACEMENTI has a medium-fine finish. For finer finishes, polish with a superfine grain sander (800-1000)
Calculate how much you need:
Suitable for the creation of highly resistant surfaces (walls and floors), continuous decorative floors and with high adhesion (any clean base such as cement, plasterboard, ceramic coatings after scratching, etc ...). Finishes similar to lime stuccos.
