- Out-of-Stock

Suitable for its mineral appearance that can be applied on concrete, lime mortars, cement and fiber cement.
Surface preparation
"Plaster, plasterboard, wood, plastic paints (drying 30 days)
- On enamels, wood, plastic materials, plasterboard, it is necessary to apply the EQUALIZATION BOTTOM as an intermediate layer, and then proceed as a substrate in good condition of regular absorption. - On emulsion paints, substrates with saline efflorescence and gypsum, it is necessary to apply the SYLIFLEX MEDIUM as an intermediate layer, as a substrate in a good state of regular absorption. On surfaces that have been painted with lime, it must be completely removed by mechanical brushing. In the case of old silicate coatings, thoroughly clean the well-adhered layers with a dry brush or water. Old layers, in poor condition, remove them by mechanical means and carefully rinse with water. Surfaces with mold problems should be brushed vigorously and cleaned with water and bleach or some specific product for mold. Later it should be rinsed with fresh water and allowed to dry. In the case of natural stone, it must be in good condition, dry and without efflorescence, if it exists, remove them with a dry brush. If there is rising soil moisture, silicate coatings deteriorate prematurely. In this case, two coats of STOPHUMIDITY Anti-Humidity Sealer can be previously applied. If there are small cracks or faults, these must be previously repaired before applying the paint.
Before applying
Working temperature. Both ambient temperature and support. Minimum: +8ºC (46.4ºF) Maximum: +25ºC (77ºF)
How to use
If the surfaces are very absorbent, it is recommended to give a coat of FASSANOL. In the case of surfaces that have cracks or large cracks, once repaired, it is advisable to intersperse between the first two hands of TEPPIGUM a mesh and, subsequently, apply a third and fourth coat. We have fiberglass meshes to reinforce, in rolls of 1 x 50 meters. Dilution: 1st Hand: 5-15%, depending on the porosity of the surfaces to be painted. Successive hands: A viscosity of supply. Application: BUCKLE or ROLLER. Occasionally it can be applied to airbrush gun (2.8 mm nozzle) or air-less (Nozzle 0.021 or 0.023" and 30 mesh filter). On surfaces in good condition, two hands will suffice.
Storage
UP TO 6 MONTHS, in places protected from frost. If the container has been opened, close it tightly and use the contents of the pack within 30 days.
Calculate how much you need: