It is very suitable as a primer layer prior to enamelling on interior or exterior surfaces of concrete, fiber cement, chipboard, plywood, plasterboard, plasterboard, etc., where a solvent-free painting system is required by toxicological or environmental considerations.
Surface preparation
The surface must be clean, dry and in good condition. Stir the contents of the container well. The product is ready for use, not dilute.
Before applying
Apply preferably between +5º C and +40º C and with a relative humidity of less than 80%. Do not apply if rainfall is expected or with very high relative humidity.
How to use
It must be applied with a brush, to ensure perfect penetration. It is recommended to make the application undiluted. The utensils used for the application of the EGARUST must be completely clean, without solvents, turpentine, etc. They can be cleaned with water, taking care not to let the residues dry. The coating of the EGARUST can be done depending on the ambient temperature, 6 hours after application.
Storage
The product must be stored in the original container, perfectly closed, in a dry and ventilated place, in accordance with current legislation. Preserve from frost or very low temperatures during storage.
Calculate how much you need:
It is very suitable as a primer layer prior to enamelling on interior or exterior surfaces of concrete, fiber cement, chipboard, plywood, plasterboard, plasterboard, etc., where a solvent-free painting system is required by toxicological or environmental considerations.
